Recently moved and connected my HR-16 receiver to an existing dish. Everything was great until a couple of weeks ago when both receivers started pixelating, sometime so much that it would loose the signal and begin "Searching for satellite". After a couple of days, I lost one satellite entirely and could only receive on a single receiver. The pixelating became worse so I changed out all the cabling all the way to the LNB. Properly grounded and it worked for a few days. So well in fact that I cancelled the original service call. Did not last long as it started up again a couple of days ago. Can't stand to watch it because of the severe pixelating and sound popping. Done the perverbial red button and power off resets, but no good. Cable length is 15 ft. Gone through the satellite setup to many times to count. Anything out there that I may have overlooked?
↧
All Channels Pixelate
↧